Command line access?

taob · Post by **taob** » Sun Feb 09, 2003 1:43 pm

Is there a way to run NI in command-line mode only? Obviously not 100% functionality, but I would like to be able to specify the input image, saved profile setting, saved filter setting, and output image. Once I have profiles created for a particular situation, I usually don't need the GUI at all.

Post by **NITeam** » Sun Feb 09, 2003 1:56 pm

Please try NeatImage.exe /?

taob · Post by **taob** » Sun Feb 09, 2003 2:04 pm

Aha... I was just going to ask about that!

I saw "Command line support" in the feature map, but there was no other mention of it in the docs. Thanks, I'll check that out.