I am a brand new user of Neat Image v4.4 Pro+ and am trying to build a device noise profile using the calibration target. I imaged the target with my digital camera and put the file on the hard drive. The manual indicates that in NI I should be able to select the "Open test image" button or select "file,Open Test Image" from the menu system. My problem is that neither of these choices is available. They are grayed out. I can choose "Open Image" but not "Open Test Image." Where have I gone astray? I am stuck at this point. I thank you in advance for your help for a struggling beginnier.
-Thanks...Dayle
Opening Test Image
Choose "Open Image" in this case.
"Open Test Image" was made for the cases when you already have some working image opened in the Filtration Job Editor and you want to build a noise profile using another (test) image. In such a case, you use "Open Test Image" to open the second image for profiling purposes. The test image replaces the working image in the Device Noise Profile tab only.
In your situation, you can simply open the Target image as input image.
Hope this helps.
Vlad
"Open Test Image" was made for the cases when you already have some working image opened in the Filtration Job Editor and you want to build a noise profile using another (test) image. In such a case, you use "Open Test Image" to open the second image for profiling purposes. The test image replaces the working image in the Device Noise Profile tab only.
In your situation, you can simply open the Target image as input image.
Hope this helps.
Vlad
