Manual fine tune clarifications
Posted: Sat Jul 30, 2005 7:05 pm
Today I've used NI for the first time and trying to figure out some procedures and terms that are confusing me
English is not my native language so it could be because of that.
The issue is "case of manual profiling" pages 24-28 in the user guide
the part that I don't understand is "manual fine tuning analyzer"
I get yellow shading on some of the equalizer sliders values.
In the user guide text red and orange are mentioned , not yellow
Yellow is mentioed later referring to values that are overridden by the user (which I did not)
Then why do I get yellow shades on some of the sliders which have not
been tweaked by me? what does it mean?(btw the numbers characters on those sliders are red)
Now when I reset an individual slider I cannot redo it so I press the auto complete button to give a value back
If I reset the whole EQ.(trash) than I am not able to proceed profiling
nothing happens when I try the auto or manual fine tune. Neither
the rough profiling isn't working. I have to reopen the image again and proceed from the begining
On page 28 there is a figure explanation for each state of the indicator elements , what does it mean "will be affected if current selection would be analyzed" can anybody elaborate on this?
I'll appreciate a lot any help! I'm a newbie I've to improve Thanks in advance!
English is not my native language so it could be because of that.
The issue is "case of manual profiling" pages 24-28 in the user guide
the part that I don't understand is "manual fine tuning analyzer"
I get yellow shading on some of the equalizer sliders values.
In the user guide text red and orange are mentioned , not yellow
Yellow is mentioed later referring to values that are overridden by the user (which I did not)
Then why do I get yellow shades on some of the sliders which have not
been tweaked by me? what does it mean?(btw the numbers characters on those sliders are red)
Now when I reset an individual slider I cannot redo it so I press the auto complete button to give a value back
If I reset the whole EQ.(trash) than I am not able to proceed profiling
nothing happens when I try the auto or manual fine tune. Neither
the rough profiling isn't working. I have to reopen the image again and proceed from the begining
On page 28 there is a figure explanation for each state of the indicator elements , what does it mean "will be affected if current selection would be analyzed" can anybody elaborate on this?
I'll appreciate a lot any help! I'm a newbie I've to improve Thanks in advance!