Page 1 of 1
Wolf Faust IT 8.7 Slides to Create Profiles
Posted: Fri Sep 16, 2005 9:31 pm
by Dean
Is it possible to use Wolf Faust IT 8.7 slides to create noise profiles for Neat Image?
Posted: Fri Sep 16, 2005 11:21 pm
by NITeam
If it provides large enough featureless areas for analysis by NI then it should be ok.
Vlad
Posted: Sat Sep 17, 2005 1:57 pm
by Dean
I plan to scan the target slides with my Minolta 5400 at 5400 dpi. I should have provided that infomation in my initial post.
Will the target slides scanned at 5400 dpi provide large enough featureless areas for analysis by NI?
Posted: Sat Sep 17, 2005 3:16 pm
by NITeam
Neat Image uses featureless areas that are approximately 100x100-pixel large. If the scan will show those target squares being larger than 100x100 then NI will be happy.
Vlad
Posted: Sat Sep 17, 2005 8:22 pm
by Dean
I haven't purchased the IT 8 target slides, yet, but I estimate that by scanning at 5400 dpi each color square of the target should be about 200x200 pixels. Each target slide contains 264 color squares and 24 larger grey scale rectangles. I assume, therefore, that by using all or many of the squares and rectangales, NI should make an extremely good profile.
Posted: Sat Sep 17, 2005 8:45 pm
by NITeam
I am sure it will. You can also use the Neat Image
Calibration Target, it should work very well too.
Vlad
Posted: Sun Apr 30, 2006 5:33 pm
by Dean
I made NI profiles with my IT-8 targets for Fuji Velvia 50 and Provia 100f. The results are great.