How to get best profile?
How to get best profile?
I am trying to get a super high quality device profile for my Canon 5D. So far I've been able to get 86% as my top score. Now I'm not sure if it makes any difference, but I'm not sure HOW out-of-focus I could get the calibration image. Should it be just sligtly fuzzy, or should it be widly out of focus so that there are only vague light and dark areas in the frame?
Are there any other tips on getting to a 100% profile quality?
Are there any other tips on getting to a 100% profile quality?
It should be slightly fuzzy.
Try to make sure you expose the calibration target in such a way that its patches cover the complete brightness range, from black to white. Use the Auto Profile with Calibration Target function to analyze the image. If the target is correctly exposed then the profile quality will be close to 100%. Check the Profile Viewer to see which values are shown there. If you still cannot get ~100% quality, let me know those values, that will help me diagnose the cause of the trouble.
Thank you,
Vlad
Try to make sure you expose the calibration target in such a way that its patches cover the complete brightness range, from black to white. Use the Auto Profile with Calibration Target function to analyze the image. If the target is correctly exposed then the profile quality will be close to 100%. Check the Profile Viewer to see which values are shown there. If you still cannot get ~100% quality, let me know those values, that will help me diagnose the cause of the trouble.
Thank you,
Vlad
-
- Posts: 16
- Joined: Thu Jul 27, 2006 3:11 pm
- Location: East Lansing, MI
Manual profiling normally does not require manual adjusment of sliders. They are usually adjusted only by the noise analyzers. It is by design that they change in 5% steps when you move them by hand. It is a subtle hint indicating that measurements by analyzers are preferred to manual adjustment.
Vlad
Vlad
yes i know,
but the fintune analyse often produce measurements over and under 5% steps. So when i like to manual profile with 5%-steps it doesn't reach the accuracy which is needed.
Maybe this could be feature suggestion?:
when the user hold the "Control(Ctr)"-Button the sliders move in 1%-steps
but the fintune analyse often produce measurements over and under 5% steps. So when i like to manual profile with 5%-steps it doesn't reach the accuracy which is needed.
Maybe this could be feature suggestion?:
when the user hold the "Control(Ctr)"-Button the sliders move in 1%-steps
greets from greece