Page 1 of 1
Separate Noise Filter Settings
Posted: Sun May 18, 2008 6:19 am
by Nightfall
I need separated High, Mid, Low noise levels for Y, Cr, Cb channels... as well as in Noise Reduction Amounts
Posted: Sun May 18, 2008 9:17 am
by NITeam
Try to process one channel at a time (for that, set the noise reduction amounts for other channels to 0%). In this case, High, Mid, Low noise levels will adjust that one selected channel only.
Vlad
Posted: Wed May 21, 2008 7:58 pm
by Nightfall
I spoke about that:
Posted: Tue Dec 16, 2008 5:45 pm
by Nightfall
NITeam wrote:Try to process one channel at a time (for that, set the noise reduction amounts for other channels to 0%). In this case, High, Mid, Low noise levels will adjust that one selected channel only.
Vlad
And what after? I need different noise setting (High, Mid, Low) for each of channels (Y, Cr, Cb). I think it is not so difficult to implement into current version of Neat Image.
