Should I Denoise then Stabilize or visa versa?
Posted: Sun Feb 03, 2019 10:54 pm
Usually, when I need to use Neat Video I'm de-noising first and then applying stabilization (Mercalli V4).
The reason is -- stabilization dynamically changing zoom factor so noise profile is changing.
However, sometimes I'm using NeatVideo to de-noise 8mm film scans.
In this case consecutive frames jumping quite a lot as old films are bent and were not holding in exact position while pulled through machine.
So I'm not sure how Neat Video temporal filter works in this case and if I need to apply stabilization first.
Any advise from developers who know how Neat Video matching the same regions in consecutive frames would be nice to have.
Thanks.
The reason is -- stabilization dynamically changing zoom factor so noise profile is changing.
However, sometimes I'm using NeatVideo to de-noise 8mm film scans.
In this case consecutive frames jumping quite a lot as old films are bent and were not holding in exact position while pulled through machine.
So I'm not sure how Neat Video temporal filter works in this case and if I need to apply stabilization first.
Any advise from developers who know how Neat Video matching the same regions in consecutive frames would be nice to have.
Thanks.