Hi! I came across a problem as I upgraded to v3 for the VirtualDub Pro plug-in yesterday.
I was trying to use a profile I used for an anime I wanted to encode from v2.6 but for some reason I keep getting some weird artifacts while trying to use it on v3 and they are not there when I go back and use v2.6 using the same source and profile. Is there anyway I could load my profile on v3 without any problems?
http://imageshack.us/f/831/newvd.png/
The screencap on the left is the original and the right is the new filtered using v3 of neat video.
Using profiles from v2.6 on v3
Perhaps it simply requires some minor adjustment of the filter (the noise levels). Or try to re-build (or Auto Fine-Tune) the profile in v3 to make it more accurate.
Remember that v3 used a modified filter, so the results may generally be different than in v2. Usually, the results are better but this depends on the filter settings too.
I would try to re-build the profile in v3 and then adjust the filter to make preview look good.
Vlad
Remember that v3 used a modified filter, so the results may generally be different than in v2. Usually, the results are better but this depends on the filter settings too.
I would try to re-build the profile in v3 and then adjust the filter to make preview look good.
Vlad