I have question in case of the BMD Cinema Camera.
When I load the "Afterglow" shot 5 into Motion 5, I cannot tell Neat Video to denoise the full range of the shot.
The image consists of very dark and mid-tones and Neat Video uses the mid-tones by default. But when I tell NV to fine-tune the profile by using the dark tones, too, I cannot see any processing in this areas.
Is there any trick or does it not work?
Thank you
Blackmagic Cinema Camera
Probably you are doing something incorrectly when you are fine-tuning the profile. Perhaps the choice of areas for analysis, or using not right control for manual fine-tuning. I cannot tell for sure without seeing what you do exactly. A correctly-built profile would make the noise filter treat the noise in the darks just as well as the noise in mid-tones and in brights.
I would need to get a reproducable example to see what exactly is going on. Could you prepare a small test case and send it to support [at] neatvideo.com?
Thank you,
Vlad
I would need to get a reproducable example to see what exactly is going on. Could you prepare a small test case and send it to support [at] neatvideo.com?
Thank you,
Vlad